Monophasic UV & LED Reconstruction Gel BUILDER MONO GEL CLEAR 15 gr
50 Item Items
Warning: Last items in stock!
HOW TO USE: 1. Disinfect the client's hand with the sanitizing solution. 2. Push all the cuticles with the pusher. 3. Clean the entire cuticle well and remove residues. 4. Carefully clean the entire surface of the nail plate with the abrasive brick. 5. Dust carefully all the dust produced with the special brush. 6. Apply a layer of Nail Prep and allow to air dry for 30 seconds. 7. Apply a layer of Ultrabond (non-acid primer) and allow to air dry for 30 seconds. Leave the sticky layer that produces after drying. 8. Place a small amount of Builder Mono Gel Clear in the center of the nail, near the C-curve. Work a thin layer of gel in the direction of the cuticles and spread it towards the tip. Avoid pouring the gel into the cuticles. Leave a thicker layer of gel in the center of the nail in order to create a perfect C-curve. 9. Cure in professional UV lamp (36 Watt) for 2 minutes or 1 minute in LED lamp (36 Watt). If using a lower wattage lamp, extend the curing time by 1-2 minutes. 10. Apply a thin and even layer of Builder Mono Gel Clear over the entire nail surface and cure as indicated above. 11. Eliminate the sticky residue with UV Gel Cleanser. 12. Shape the nails with the file making them thinner near the cuticles and tips, and leaving them thicker at the point of stress. 13. Apply a thin layer of Builder Mono Gel Clear as a top gel or a finishing gel. 14. Polymerize as indicated above. 15. Remove the sticky residue again. WARNINGS: Keep the product in a cool and dark place. Do not expose to light or excessive heat. Use only as directed. Harmful if inhaled, may cause sensitization in contact with skin. Avoid contact with skin and eyes, after contact with skin, wash immediately with plenty of water, wear suitable protective gloves. In case of accident or if you feel unwell, immediately contact a doctor (show this label if possible).